国产在线视频97_欧洲日韩亚洲无线在码_亚洲国产资源在线看午夜天堂_午夜性色福利视频性色_国产一级a在看片免费视频观看_福利导航av天堂中文在线_白浆高潮国产伦理电影_关于黄瓜视频的软件_五月婷婷激情五月中文字幕_欧美亚洲一级一级

Welcome to Qingzhou Taihe Lihua New Material Technology Co., Ltd.

Your Position: Home ? Product Display ? Water-based dry complex adhesive

Water-based dry complex adhesive

Focus on the development and production of environmentally-friendly water-based adhesives
Water-based dry complex adhesive

Water-based dry complex adhesive

Class: Water-based dry complex adhesive
Date: 2017-11-30

Return

Product description

I. Applicable scope 

For paper printing materials and BOPP, PET film, drying tunnel type, dry type complex, and more suitable for high-speed complex. It can be directly pressed for a variety of printing surfaces and can be cut online. It can completely dissolve the lithographic spray powder to improve the flatness of printing surface. 

 

II. Technical specification 

Main composition: Acrylate copolymer 

Appearance: White emulsion with blue light 

PH value: 8.0±1.0 

Solid content: 48.0±2.0% 

Viscosity (painted-4#): 18~25 

 

III. Application method 

1. It is recommended that the temperature of heating godet of laminating machine shall be increased to 50℃-90℃, and the temperature of drying tunnel shall be increased to 60℃-90℃. 

2. This product does not need to add any solvent for mixing. The complex film adhesive is directly poured into the adhesive container. Then it can be immediately laminated after the adhesive roller is coated with adhesive and mixed well. 

3. If the white duplex board is complexed, the adhesive emulsion accompanied with BOPP film must be dried completely after BOPP film is taken out from the drying tunnel. And it is appropriate that the adhesive emulsion cannot be squeezed out from two sides of film after passing the pressuring heating godet;  Composite gold and silver cardboard or gold- and silver-printed products must be dried up completely   

4. The coated product can be cut directly, and the peel strength can reach higher values after 24 hours. 

5. The speed of machine, drying tunnel, temperature of heating godet and amount of adhesive shall be flexibly grasped by user according to the equipment, type of compound products and actual situation. 

 

IV. Precautions 

1. The used thin film must go through corona treatment and be up to standard, which goes above 38 dyne. 

2. Mustn't be mixed with other cementing compound; 

3. Due to low environmental temperature in winter, the composite products should avoid being kept at low temperatures for a long time to the greatest extent before being dried up; 

4. Rinse glue spreader in time once it stops working; 

5. It is advisable to make a proof to ensure color retention and bonding strength before processing gold and silver printed surfaces; 

6. If such cases as below should occur or there are post-processing composite products, samples must be conducted before mass production; 

a. Embossing b. Concave-convex; c. Papering; d. Rough paper; e. Surfaces with relatively thick ink layers or comparatively more liquid driers. 

7. The proper storage temperature for glue is 4-35℃ with a shelf life of 6 months. 

 

V. Packaging 

Plastic bucket (lining plastic bags)packaging, 50kgs net each